High altitude performance can be improved by specific modifications to the carburetor. Return the starter grip gently. Ignition switch The remote control box is equipped with a key type ignition switch. High altitude performance can be improved by specific modifi- cations to the carburetors. American Honda provides the same emission warranty coverage for outboard engines sold in all 50 states. Spark plug faulty, fouled or improperly gapped. Steering To turn to the right, swing the steering swing the handle to the right.
Fuel Level Check the fuel gauge and refill the tank if. Turn the bolt clockwise to increase steering friction for holding a steady course. The long shaft motor requires about 20 in. Never refill the fuel tank inside a building where gasoline fumes may reach flames or sparks. Is the fuel cap knob turned 4.
See the Honda Shop Manual. If you are far from a dealer, proceed as follows: Remove the engine cover, and rinse the outboard motor with. If the engine protection system remains activated after 30 seconds, return to the nearest boat landing, and have the outboard motor inspected by an authorized Honda marine dealer. Repair any fuel leaks if necessary. To meet clean air standards, some areas of the United States and Canada use oxygenated fuels to help reduce emissions. Securely connect the fuel hose connector to the outboard motor refer to page 38. If your portable fuel tank contains gasoline, store it away from any.
Move the control lever to the N neutral position. Gearshift lever not in neutral position. Close the fuel cap vent knob. This will provide mixture and the correct fast idle. An indicator at the base of the gearshift lever aligns with the letters F, N. It must be in the N neutral position for starting. Vent knob is not open or vent is clogged.
When oil filter is not replaced qt 2. Failure to properly follow maintenance instructions and precautions can cause you to be seriously hurt or. R reverse : The boat reverses. Always stop the engine if you must leave the controls for any reason. Do not overfill the tank there should refueling, make sure the tank cap is closed Be careful not to spill fuel when ignite. Before replacing the propeller or the shear pin, remove the clip from the engine stop switch to prevent any possibility of the engine being started while you are working with the. And using this outboard motor safely is an important responsibil- ity.
The emergency stop switch clip must be engaged with the emergency engine stop switch or the engine will not start. Additionally, your warranty does not apply to the normal wear of items such as spark plug s , water pump, etc. Move the control lever to the N neutral position. Other Checks Check the following items. The problem is that once you have gotten your nifty new product, the honda outboard motor owners manual gets a brief glance, maybe a once over, but it often tends to get discarded or lost with the original packaging. Take outboard motor to an authorized Honda marine dealer, or refer to the shop manual. If there is a Honda marine dealer nearby, take the motor to the dealer immediately.
Keep the portable fuel tank away from the battery or other potential spark sources. Fuel No gasoline in fuel tank. Spark plug wet with fuel flooded engine. Move the gearshift lever to the N neutral position and stop the engine. Fuel filter or fuel tank filter restricted.
Wash the outside of the outboard motor with clean, fresh water. After the spark plugs are seated, tighten with a spark plug wrench to compress the washers. It is intended to be used by a skilled technician. Be sure all water has drained from the outboard motor before placing it on its side, so no residual water can enter the engine exhaust port. Install the new ,propeller in the reverse sequence to removal. Next 45 minutes: Run the outboard motor up to a maximum of 2,000 to 3,000 rpm or 10% to 30% throttle opening. The steering should move smoothly and freely.