Laserprodukten van klasse I worden niet als ongevaarlijk aangemerkt. More information is available on our Lexmark Web site at www. See Loading standard trays and optional trays for help. Register a Free 1 month Trial Account. Information on whether your vinyl label converter has passed Lexmark criteria is available at the Lexmark Web site www. Le caratteristiche di sicurezza di alcune parti non sempre sono di immediata comprensione.
Install a printer driver on the attached computer. Example: 241 is a Paper Jam Tray 1 Action Pass Thru Sensor and Flag The tray x option system board did Assembly not detect a piece of paper actuating. Mounting slot Mounting bracket 5 Place the tips of the wire paper bail into the Paper stops ends of the plastic bracket so that the bail curves downward. Note: A 201 paper jam may also indicate a failing printhead. Loosen, but do not remove, the six screws on the shield.
Wait for the configuration to complete. Allow at least as much space as shown in the illus- 137. Warning: Avoid damage to the cables and connectors. Configuration Menu - Contains a set of menus, settings, and operations that are generally used to configure the printer for operation. Place the duplex unit on top of any installed drawers or the table or printer cabinet where you plan to use the printer.
Order new pick rolls when the paper fails to properly feed from the tray. Locate the integrated tray compensator assembly B on the bottom of the printer and disconnect the compensator arm bias spring from the frame. Action Stapler Assembly Check the stapler assembly for any signs of broken or damaged parts. Note: Load only one size and type of print media at a time in the multipurpose feeder. Avoid forcing to print more than its capacity. The bail rests in the printer output tray. Note: When replacing staples in the supply cartridge, discard any old staples in the cartridge and replace with a fresh strip.
If staples are jammed in the cartridge, replace the old strip of staples with a new strip and try the finisher feed test from the diagnostic menu. Check to make sure the motor cable is connected to the envelope system board. Remove the printhead mounting screws B. Lift the envelope feeder up out of the printer, and then set it aside. After you carefully unpack the output expander, install it immediately; otherwise, the edges of the mounting brackets could damage tabletops or fab- rics. Select the network printer from the Shared printers list. Unsnap the transfer roll assembly from the left pivot arm.
. Post Incomplete - Insert Stapler Cartridge Displayed Cartridge Holder is installed and cannot clear message When this failure occurs, the following may also occur in the order shown: 1. The printer prints a new copy of the page that jammed if Jam Recovery is set to On or Auto; however, the Auto setting does not guarantee the page will print. The printer automatically rec- 500-sheet drawer ognizes any drawer that has been installed. See Ordering supplies for more information on obtaining a fuser cleaner. Disconnect the operator panel cable. All models sup- port a duplex unit and envelope feeder.
Once the Quick Test Page completes printing, the Registration screen displays again. Warning: Printer memory memory cards are easily damaged by static electricity. Disconnect the printhead cables A from the printhead 3. Setting parameters in the printer Press on the operator panel. The job is held in memory until you delete it from the Held Jobs menu.
It is divided into the following chapters: 1. Download and install the software. The voltage measures approximately +5 V dc. Select Standard Bin from the menu. Remove the main drive assembly.
Remove the left and right side frames. Lift and pull the print cartridge out of the printer. Remove the paper from tray x and check for the natural curvature in the paper. Do not use a shipping or transport method that requires the printer to be shipped without a pallet. If service error code 930 displays, the wrong printhead is installed in the printer.